Skip to main content

    WiFi and network installation Las Vegas

    JDM Automations provides WiFi and network installation in Las Vegas for homes and businesses, also serving Henderson, Summerlin and North Las Vegas, starting with a free on-site consultation.

    Cameras, streaming, smart home devices and working from home all sit on top of one thing: the network. We design and install home and business networks across Las Vegas — routers, switches, wired backhaul and access points placed where the coverage actually needs to be.

    WiFi and network installation Las Vegas: planning your installation

    Local construction is not kind to wireless signal. Stucco over wire lath acts like a screen against radio waves, block and masonry walls absorb signal, and low-E window coatings reflect it. A single router in a corner of the house — which is where the internet service usually enters — is fighting all of that at once.

    Layout makes it worse. Long single-story floor plans, detached casitas, garages, pool areas and backyards are all common here, and all sit well outside the useful range of one router. The fix is almost never a bigger router; it is more access points, placed properly, each fed by a cable.

    How We Design a Network

    We start by walking the property and finding where coverage is actually needed, including outdoor areas. Then we pick access point locations that split the space sensibly, plan a wired run to each one, and size a switch with enough Power over Ethernet capacity to feed them along with any cameras.

    Wired backhaul is the part people skip and later regret. A mesh system that relays wirelessly loses throughput at every hop and struggles in exactly the construction described above. The same access points, each connected by Cat6, behave completely differently. Where a run truly cannot be pulled, we use a wireless uplink deliberately rather than by default.

    Configuration is the rest of the job: sensible channel and band settings, a separate network for guests, a segment for smart home and camera devices, and naming that makes the network understandable later. For businesses we add VLAN segmentation and remote management so changes do not require a site visit.

    Equipment We Install

    We install and configure Ubiquiti UniFi networks — gateways, switches and access points managed from one controller — along with consumer mesh systems where that is the right fit for the budget and the building. For camera-heavy properties we deliberately pair the network with UniFi Protect so the whole system is managed in one place.

    We also work on existing networks. If your equipment is fine but placed badly or configured poorly, we will say so rather than sell you replacements.

    Network Services We Provide

    • Wi-Fi coverage assessment and design
    • Ceiling and wall access point installation
    • Wired Ethernet backhaul to every access point
    • Managed and PoE switch installation
    • UniFi and Ubiquiti network deployment
    • Mesh Wi-Fi system setup
    • Guest and smart-home network separation
    • VLAN segmentation for business networks
    • Outdoor, patio and casita coverage
    • Existing network troubleshooting and repair

    How the Installation Works

    1. 1

      Assess

      We check coverage, speeds and dead zones throughout the property, indoors and out.

    2. 2

      Design

      Access point placement, cable routes and switch sizing, quoted before work starts.

    3. 3

      Install

      Cable pulled, access points mounted, switch and gateway installed and configured.

    4. 4

      Verify

      We re-test coverage in every area and tune settings before handing it over.

    Frequently Asked Questions

    How do I fix Wi-Fi dead zones in my house?

    Usually by adding access points rather than upgrading the router. One device cannot cover a long floor plan through stucco and block walls. Two or three well-placed access points, each fed by an Ethernet cable, will outperform any single router. We identify the dead areas first, then place hardware to match the floor plan.

    Is mesh Wi-Fi good enough, or do I need wired access points?

    Mesh is convenient and fine for smaller homes with few walls. In a larger or masonry-heavy home, wireless relaying costs a significant share of throughput at each hop. Running a cable to each access point removes that penalty entirely, and most mesh systems support wired backhaul if you have the cabling.

    Can you install equipment I already bought?

    Tell us the make and model during your free on-site consultation. Compatibility, condition and the installation scope are confirmed before we recommend using or replacing existing equipment.

    Do you serve businesses as well as homes?

    Yes. JDM Automations provides low voltage installation for homes and businesses in the Las Vegas valley and listed nearby service areas. We confirm the requirements for your property during the consultation.

    How long does installation take?

    Timing depends on the equipment, cable routes, wall construction and access to the property. We confirm the expected installation schedule during your free on-site consultation rather than promising a fixed duration.

    Do you offer a free on-site consultation?

    Yes. Call (702) 874-8777 or request a consultation through our contact page. Our hours are Monday–Friday and Saturday, 8:00 AM – 4:00 PM. Call or text during business hours.

    Where We Work

    JDM Automations serves homes and businesses across the Las Vegas valley and nearby communities.

    Tired of Dropouts and Dead Zones?

    We'll assess coverage across your property and design a network that actually reaches every room.